Reading data into physica
When you have quit physica it ``forgot'' what vectors x, y,
dy were, and if you want to look at them again for some reason, you
need to re-type them. A more convenient approach would have been to
enter your data into a file using your favourite editor first, and then to
read that file into physica at will. In fact, you may already
have created this file from the previous tutorial session, when you
practiced using vi or gedit. Otherwise, create this file
(call it file.dat) now, using your favourite editor outside of
physica. You may want to open a separate shell window for this
purpose, putting your physica session aside for a moment.
Enter the following data into this data file:
1.0 0.05 0.02
2.0 0.10 0.07
3.0 0.14 0.01
4.0 0.19 0.04
5.0 0.25 0.05
6.0 0.30 0.10
7.0 0.34 0.02
8.0 0.40 0.04
i.e. the same data as we used before, now entered as three
columns.
Start physica again, or move your mouse to the physica window,
and use a single read command
to create all three vectors of our simple example:
read file.dat x,y,dy
list x,y,dy
Use the list command to verify that the data has been read in
correctly. Other commands required to generate the plot of Figure 1
used in the previous section of this tutorial remain exactly the same.
Test yourself: try to generate this plot again.
Up: A simple example
Next: Programming with physica macros
Previous: A simple example
|